Home » Fabric Cutters » HSG-3-VW Heat Cutter (500W/110V)

HSG-3-VW Heat Cutter (500W/110V)

HSG-3-VW Heat Cutter - Larger unit with temperature control, suitable for a more continuous cutting operation. This unit has a stand-by temperature, the blade is pre-heated when the unit is turn on, therefore allowing quicker operation. It is designed to cut & seal synthetic fabric, cords, ropes, webbing, and belts.

The HSG-3-VW with its 500 watts is our higher-range unit for a manual production application where continuous longer and thicker material cuts are made. The more wattage in a unit helps keep the blade temperature more consistent during cuts with less cooling of the blade. The 500 watt transformer for this unit is installed in the unit box that sits on a table, making the handle lighter. On the unit box you have an on/off switch and a dial to control the heat of the blade after the trigger is pressed. This unit comes standard with a 2 meter (6.56 ft.) cable running from the unit box to the Type M handle where the blade is installed. Install your preferred blade into the Type M handle, plug in the power cord into a 110 volt outlet, set the dial to the recommended setting for your particular blade listed in the owner’s manual, turn on the unit with the on/off switch and you're ready to cut and seal synthetic fabric/rope/webbing in a production atmosphere. 

This unit is available in 220 volts as a special order. 

Blades are sold separately. Recommended blades for this particular unit can be found by clicking the "Related Blades" tab below. 

H/125 In Stock

Related Products

Heat up Time: 6-8 seconds

Working temperature: 600°C (1110°F) max.

Supply voltage: 110V - 60Hz

Power input: 500 Watt max.

Continuous operation

Stand-by-temperature for quicker operation

Illuminated rocker switch

Power cord: Standard 2 m, with US-type plug. 

Cable from unit to handle: Standard 2 m Cable (3 m or max. 5 m cable also available for additional cost)

Class I protection

Dimension: 300 x 185 x 170 mm (11.8" x  7.2" x 6.6")

Weight: 13,0 kg (28.5lbs)

Made in Germany

Recommended diameter for round and square blades: 2mm - 160mm

 Limited 1 year warranty covering manufacture defects.

Important Note:
We do not recommend cutting any type of PVC (Polyvinyl Chloride) or PVC coated materials with HSGM equipment because of the dangerous fumes it releases. We do recommend wearing a breathing filter mask while cutting any type of material with HSGM equipment. Also always review the materials MSDS (Material Safety Data Sheet) before cutting with HSGM equipment.